Umarex H&K Tactical .22 Rimfire 416 Compensator

[Navspecwar]

Hello Guys new to the forum, thanks for the opportunity to pick your brains on a question I have on installation of the H&K Tactical .22 Rimfire 416 Compensator from Umarex (http://www.umarexusa.com/product/HK-Tactical-22-Rimfire-416-Compensator,289,38.htm)

Just wondering if anybody has installed one of these on thier HK416 22lr, and if so anything special I should know about the installation. There were no instructions with the compensator when I recieved it in the mail, and no adaptor. Any assistance or advise you could provide would be greatly appreciated!

Thank You

[Navspecwar]

Folks forget the question, I went to T22 (http://www.tacticool22.com/) and purchased a mill-spec, made in the US, compensator and associated hardware. The Umarex hardware came from Taiwan, got it figured out just fine, but did care fore the quality of the product or the stability of the installation...zero confidence in product performance.

[chrischoi]

Can you share a link of which one you bought? Thanks.

[Navspecwar]

Chris

For the HK416 D 22lr I had to go with the short shroud 4.5 inches:

http://www.tacticool22.com/shop/index.php?main_page=product_info&cPath=2&products_id=10

I also had to purchase

1. Crush Washer    http://www.tacticool22.com/shop/index.php?main_page=product_info&products_id=50

2. Barrel Thread Converter http://www.tacticool22.com/shop/index.php?main_page=product_info&products_id=1