Jump to content
Rimfire World Community
Visit Brownells Visit AR15 Builder Visit Visit Site Visit Ballistic Advantage Visit Aero Precision Visit Cabelas

New Reloading Gear


Recommended Posts

I finally got it all put together and attached to the table. Works very well now I can quickly change out the press which is at the front of the table, just loosen 4 screws a bit, and pull out an indexing pin. I've already got the required bases on both of my progressives, the single stage press and the powder measure. I plan on making bases for the RCBS trimmer and the Shotgun press.





Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...